install easily. connect securely. manage remotely.
Submitted by geo on Wed, 01/30/2008 - 22:43.
in

here are two different ways to reset your unit to factory defaults:

  1. You can use the Device Manager to reset the Junxion Box to factory defaults without powering off the unit.

    • First access the Device Manager by entering 192.168.2.1/admin (or the custom IP address you've configured for the Junxion Box LAN) into the address field of your browser. The default username is 'admin' and the password is 'junxion' unless you have already changed the password.

    • To reset your Junxion Box settings, go to the Update Page and select the Factory Defaults Reset. This resets all of your settings (passwords, LAN and WAN configuration, security settings, splash page, etc.) to the original factory settings.

  2. If you forget your device manager password or are unable to access the Device Manager, you can reset the Junxion Box during the boot process.

    • Restart the Junxion Box by pressing the power cycle switch or removing then re-inserting the power cable.

    • After one to two minutes, the status light will begin to blink rapidly.

    • Unplug the Junxion Box while the status light is rapidly blinking to reset all configuration settings back to factory defaults.

    Note. This procedure works only if the Factory Default Reset Option At Boot option is on. You'll find this option in the Update page; it's on by default.